GX - 50 - KT - THREE PHASE
A grid-tie inverter converts direct current (DC) into an alternating current (AC) suitable for injecting into an electrical power grid, normally 120 V RMS at 60 Hz or 240 V RMS at 50 Hz. Grid-tie inverters are used between local electrical power generators: solar panel, wind turbine, hydro-electric, and the gri d. To inject electrical power efficiently and safely into the grid, grid-tie inverters must accurately match the voltage, frequency and phase of the grid sine wave AC waveform.



Grid Tied

Grid Tied

Grid Tied
Features
• 1.6x DC Overload
• 1.1x AC Output Overload
• I-V Scanning and Intelligent Diagnosis
• IP66
• Intelligent Fault Detection
• 10 MPPT
• Anti-PID Optional
GX30KT Three Phase
GX50KT Three Phase
GX60KT Three Phase
GX110KT Three Phase
GX30KT Three Phase

Specification | GX30KT Three Phase |
---|---|
Total Energy Capacity | 600 |
Energy, 80% DoD [kWh] | 480 |
Energy, 90% DoD [kWh] | 540 |
Current Capacity [Ah] | 1 200 (1000) |
Max. & Cont. Charge and Discharge Current [A] | 800 |
Max. & Cont. Charge and Discharge Power [kW] | 400(500) |
Nominal Voltage [V] | 512 (614) |
Max/Min Operating Voltage [V] | 568/456 [681/547] |
Max. Inverter Capacity [kVA] | 400 (500) |
Total Weight [tonne] | 5290 |
Height (upright against wall) [mm] | 1450 |
Depth (from wall) | 725 |
Length (width along wall) [mm] | 4 226 |
DC Cables (no. per electrode) [mm2] | 1×185 |
Round Trip Efficiency | 97-97% |
Enclosure Details | 3mm thick Aluminium, powder coated, tamper proof, indoor use |
External Interface | CAN Bus |
On-board Management | Full battery management system and internal trip protection |
Human Interfaces | On and Off Buttons, State of Charge Display (0 to 100%), Error light, Error Reset Button, USB Plug for Programming and data access with PC, main breaker |
Protection | Shunt Trip Circuit Breaker sized to suit max current, can be tripped by BMS if critical fault, manual reset. Protection for overcurrent, cell under and over voltage, temperature, weak cell detection and other critical events |
Battery Chemistry | Lithium Iron Phosphate (LiFePO4) |
Cell Form Factor | Large Format ultra-heavy-duty prismatic cells of 200Ah each and 3,2V nominal voltage, fully sealed in plastic casing with bolt on electrode connections |
Battery Cooling | Natural Convection (heat generation is negligible inside the battery) |
Suitable Ambient Temp [°C] | 0°C to +40°C |
Extreme Operating Temp [°C]4 | -20°C to +60°C |
Remote Monitoring | Real time data logging and transmission via WiFi to online portal of key battery information |
Warranty | 10 years or 4000 cycles for average 80% DoD, and max 90% DoD |
Service Life – Cycles | >16 years (>5 500 cycles) expected life at 80% DoD per cycle, >20 years (7 500 cycles) at 50% DoD |
GX50KT Three Phase

Specification | GX50KT Three Phase |
---|---|
Total Energy Capacity | 600 |
Energy, 80% DoD [kWh] | 480 |
Energy, 90% DoD [kWh] | 540 |
Current Capacity [Ah] | 1 200 (1000) |
Max. & Cont. Charge and Discharge Current [A] | 800 |
Max. & Cont. Charge and Discharge Power [kW] | 400(500) |
Nominal Voltage [V] | 512 (614) |
Max/Min Operating Voltage [V] | 568/456 [681/547] |
Max. Inverter Capacity [kVA] | 400 (500) |
Total Weight [tonne] | 5290 |
Height (upright against wall) [mm] | 1450 |
Depth (from wall) | 725 |
Length (width along wall) [mm] | 4 226 |
DC Cables (no. per electrode) [mm2] | 1×185 |
Round Trip Efficiency | 97-97% |
Enclosure Details | 3mm thick Aluminium, powder coated, tamper proof, indoor use |
External Interface | CAN Bus |
On-board Management | Full battery management system and internal trip protection |
Human Interfaces | On and Off Buttons, State of Charge Display (0 to 100%), Error light, Error Reset Button, USB Plug for Programming and data access with PC, main breaker |
Protection | Shunt Trip Circuit Breaker sized to suit max current, can be tripped by BMS if critical fault, manual reset. Protection for overcurrent, cell under and over voltage, temperature, weak cell detection and other critical events |
Battery Chemistry | Lithium Iron Phosphate (LiFePO4) |
Cell Form Factor | Large Format ultra-heavy-duty prismatic cells of 200Ah each and 3,2V nominal voltage, fully sealed in plastic casing with bolt on electrode connections |
Battery Cooling | Natural Convection (heat generation is negligible inside the battery) |
Suitable Ambient Temp [°C] | 0°C to +40°C |
Extreme Operating Temp [°C]4 | -20°C to +60°C |
Remote Monitoring | Real time data logging and transmission via WiFi to online portal of key battery information |
Warranty | 10 years or 4000 cycles for average 80% DoD, and max 90% DoD |
Service Life – Cycles | >16 years (>5 500 cycles) expected life at 80% DoD per cycle, >20 years (7 500 cycles) at 50% DoD |
GX60KT Three Phase

Specification | GX60KT Three Phase |
---|---|
Total Energy Capacity | 600 |
Energy, 80% DoD [kWh] | 480 |
Energy, 90% DoD [kWh] | 540 |
Current Capacity [Ah] | 1 200 (1000) |
Max. & Cont. Charge and Discharge Current [A] | 800 |
Max. & Cont. Charge and Discharge Power [kW] | 400(500) |
Nominal Voltage [V] | 512 (614) |
Max/Min Operating Voltage [V] | 568/456 [681/547] |
Max. Inverter Capacity [kVA] | 400 (500) |
Total Weight [tonne] | 5290 |
Height (upright against wall) [mm] | 1450 |
Depth (from wall) | 725 |
Length (width along wall) [mm] | 4 226 |
DC Cables (no. per electrode) [mm2] | 1×185 |
Round Trip Efficiency | 97-97% |
Enclosure Details | 3mm thick Aluminium, powder coated, tamper proof, indoor use |
External Interface | CAN Bus |
On-board Management | Full battery management system and internal trip protection |
Human Interfaces | On and Off Buttons, State of Charge Display (0 to 100%), Error light, Error Reset Button, USB Plug for Programming and data access with PC, main breaker |
Protection | Shunt Trip Circuit Breaker sized to suit max current, can be tripped by BMS if critical fault, manual reset. Protection for overcurrent, cell under and over voltage, temperature, weak cell detection and other critical events |
Battery Chemistry | Lithium Iron Phosphate (LiFePO4) |
Cell Form Factor | Large Format ultra-heavy-duty prismatic cells of 200Ah each and 3,2V nominal voltage, fully sealed in plastic casing with bolt on electrode connections |
Battery Cooling | Natural Convection (heat generation is negligible inside the battery) |
Suitable Ambient Temp [°C] | 0°C to +40°C |
Extreme Operating Temp [°C]4 | -20°C to +60°C |
Remote Monitoring | Real time data logging and transmission via WiFi to online portal of key battery information |
Warranty | 10 years or 4000 cycles for average 80% DoD, and max 90% DoD |
Service Life – Cycles | >16 years (>5 500 cycles) expected life at 80% DoD per cycle, >20 years (7 500 cycles) at 50% DoD |
GX110KT Three Phase
Specification | GX110KT Three Phase |
---|---|
Total Energy Capacity | 600 |
Energy, 80% DoD [kWh] | 480 |
Energy, 90% DoD [kWh] | 540 |
Current Capacity [Ah] | 1 200 (1000) |
Max. & Cont. Charge and Discharge Current [A] | 800 |
Max. & Cont. Charge and Discharge Power [kW] | 400(500) |
Nominal Voltage [V] | 512 (614) |
Max/Min Operating Voltage [V] | 568/456 [681/547] |
Max. Inverter Capacity [kVA] | 400 (500) |
Total Weight [tonne] | 5290 |
Height (upright against wall) [mm] | 1450 |
Depth (from wall) | 725 |
Length (width along wall) [mm] | 4 226 |
DC Cables (no. per electrode) [mm2] | 1×185 |
Round Trip Efficiency | 97-97% |
Enclosure Details | 3mm thick Aluminium, powder coated, tamper proof, indoor use |
External Interface | CAN Bus |
On-board Management | Full battery management system and internal trip protection |
Human Interfaces | On and Off Buttons, State of Charge Display (0 to 100%), Error light, Error Reset Button, USB Plug for Programming and data access with PC, main breaker |
Protection | Shunt Trip Circuit Breaker sized to suit max current, can be tripped by BMS if critical fault, manual reset. Protection for overcurrent, cell under and over voltage, temperature, weak cell detection and other critical events |
Battery Chemistry | Lithium Iron Phosphate (LiFePO4) |
Cell Form Factor | Large Format ultra-heavy-duty prismatic cells of 200Ah each and 3,2V nominal voltage, fully sealed in plastic casing with bolt on electrode connections |
Battery Cooling | Natural Convection (heat generation is negligible inside the battery) |
Suitable Ambient Temp [°C] | 0°C to +40°C |
Extreme Operating Temp [°C]4 | -20°C to +60°C |
Remote Monitoring | Real time data logging and transmission via WiFi to online portal of key battery information |
Warranty | 10 years or 4000 cycles for average 80% DoD, and max 90% DoD |
Service Life – Cycles | >16 years (>5 500 cycles) expected life at 80% DoD per cycle, >20 years (7 500 cycles) at 50% DoD |
Other Products

Products
- All In One Inverter
- Hybrid Inverter
- Commercial Hybrid Energy Storage
- Grid Tied Inverter
- Off-Grid inverter
- Outdoor Inverter
- Lithium Batteries